Views: 9 Author: Site Editor Publish Time: 2026-11-16 Origin: Site
When the temperature drops below freezing, the cooling water inside the laser water circuit freezes and expands. The resulting force can rupture pipelines and damage optical cables.
A single oversight may lead to costly repair fees and lengthy production downtime. Proactive protection is critical to keep your equipment running stably and safely through cold weather.
Below are key procedures and precautions for lasers operating in low-temperature environments:
Antifreeze effectively lowers the freezing point of cooling water to prevent freezing and expansion, protecting water circuits and optical components.
Recommended professional brand: Clariant Antifrogen N (pale yellow liquid).
A 3:7 mixing ratio for Clariant antifreeze (30% antifreeze + 70% deionized water) delivers protection down to -20℃.
1. Power off all equipment (chiller, laser, etc.). Open the drain valve of the chiller to drain all water from the water tank, rinse the tank with clean water, then drain it again.
2. Remove, clean and reinstall the filter cartridge of the chiller and the filter at the laser inlet.
3. Pour the pre-mixed antifreeze and deionized water into a separate container and stir thoroughly before filling the chiller tank. (Do NOT pour them directly into the chiller; insufficient mixing will form flocculants that clog filters and cartridges.)
Antifreeze is not for permanent use. Once the cold season ends, flush the entire water circuit thoroughly and revert to deionized water or distilled water.
For long-term shutdowns (e.g., Spring Festival holiday), drain all cooling water and blow the water circuit dry with dry compressed air to avoid internal freezing.
Tap water and bottled purified water are prohibited, as they cause scale and microbial growth that clog pipelines.
· Cooling water specification: Only distilled water or deionized water is permitted.
· Replacement cycle: Replace water every 3 months to prevent water deterioration.
· Bacteria control: Add 5%–10% alcohol to suppress bacteria and algae growth.
Prevention is the only way to avoid losses. Please implement protective measures promptly according to local climate and equipment operating conditions.
For further assistance, feel free to contact our service team.